|Address||Guelph, ON N1H7Z5
Hello my name is Chris Saur, I am located in Guelph Ontario Canada. The
reason I am on here, I found there was a need for mg sheet
metal. I am a tool and die maker by trade and built a die to stamp a right and
left floor pan for 1968 to 1980 and the older sets 1962-1967, made of 18 gauge galvanneal
steel. Welds like regular steel but will never rust and a little thicker than original.
All floor pans have the seat nuts welded on,and have the studs for the fuel and brake lines 1/4 28 thread. I ship all over the USA and Canada. A set is $250 Canadian and single pan is $145.
The next die that I will have complete is the rocker panel. If you
have any questions please let me know. These floor pans will fall right into place as there is an mg in my garage used as a fixture. Also selling toe board repair panel, inner rocker repair panel,
side member repair panel, and a few others.
For floor pan orders, email me back or please visit me on facebook, "royal restoration" or on
Instagram "royalrestorationmg". phone 1-226-500-6554
If you know of anybody who needs floor pans, I would appreciate if you forward this info.
I do have references on the pans in the US and Canada, just ask for them.
Please leave your number or email when replying to this email