Motorcycle Lift, ATV, Gulf Cart Snowmobile Etc. Lift Work Table

The price is $850 Firm.

For sale a heavy duty, wide, home made motorcycle lift.

It lifts up a Goldwing without any problems.

You can use it for ATVS, Gulf Carts, Snowmobiles, Snow blowers, Lawn mowers, or you can even use it as a work table like I did for the last 5 years.

The work surface/table is 84 inches long x 36 1/4 inches wide x 14 3/4inches high in the lower position and it goes up to 25 inches high when you hook it up to the air compressor.

So the travel at the moment is 10 1/4 inches.

This is a heavy duty lift as you can see by the size of the cylinder that is being used.

The frame is made of square steel stock and it is braced underneath for extra support.

You could modify the links that bolt on to the cylinder on the top and bottom and the stops in front and in the back to make it go higher or lower depending on your needs.

The air hook up has a brass T fitting so if you have it hooked up to the compressor you have an extra line to operate your air tools.

I added a rubber mat, that was on another lift that I sold and I also added the front part of an aluminum Condor Pit Stop Motorcycle Wheel Chock, PS-1500, right beside the other front wheel stop that is in the middle, so if you want to put the bike on the right side of the lift so you have more room for the longer side stands and you are able to fold it down or just pull the pin out of the mount that stays on the lift and the front part moves out of the way.

See 3rd view.

The price is $850 Firm.

If you want to purchase the black steel ramp that is in the pictures it would be $75 extra if you buy the lift or $100 if you just want to purchase the ramp by itself.

Call George at Chifor Racing 519-969-8734.