|Address||Saint Thomas, ON N5P3T3
- CLENTEC ATLAS -
- SALES - INSTALLATION - SERVICE - PARTS -
- ATLAS AUTOMOTIVE EQUIPMENT -
- Tel - 647 2072081 / 226 2367379 -
The Atlas Kwik Bay is a free standing 7,000 lb. capacity portable scissor lift. The Atlas Kwik Bay is the perfect lift for body shops and wheel service specialists that need extra lifting height. This portable lift easily raises a 7,000 LB. car or truck to a comfortable working height and does not require the customer to position arms under the lifting points of the car. The vehicle is driven over the scissor ramps and the operator simply positions the heavy duty rubber block assemblies under the correct lifting points. The operation is very quick and the chance for any damage to the underside of the car is minimal.
The unique open middle of the Atlas Kwik Bay allows access to many areas on the underside of the car that are not easily accessible with other portable mid-rise lifts employing a full superstructure.
The dual power cylinders and the solid safety lock bars make the Atlas Kwik Bay one of the most versatile and easy to use scissor mid-rise lifts sold in the USA and Canada.
Each hinge point has a zerk grease fitting to allow maximum lubrication to each joint.
Our Atlas Kwik Bay has been thoroughly tested to meet Industry standards. The Atlas Kwik Bay scissor mid-rise lift is powered by a 110 volt power unit that is mounted on a movable cart. The power unit can be remotely located near the lift for maximum efficiency. This cart is also used to move the Atlas Kwik Bay on a smooth surface. The lift can be rolled to and from an inside work bay to an outside concrete apron work area.
The Atlas Kwik Bay is the ultimate scissor mid-rise lift that includes one set (4) of positioning blocks.
The large “foot print” of the Atlas Kwik Bay creates a steady platform for any raised vehicle. The Atlas Kwik Bay has a lifting height of over 39” and remains rock solid at all safety lock positions.
The electric motor for the power unit requires 110 Volt (single phase) 60 Hz. We recommend using at least a 10 gauge (grounded) wire from the electrical panel. The power unit has a short pigtail (no plug) that can be wired to either a quick disconnect box (mounted on the lift column) or to a male/female plug combination.
• 7,000 LB. Capacity
• One set (4) of positioning blocks
• Zerk grease fittings at hinge points
• Ramps lock horizontally to extend runway length
• 120V motor
• Open middle for easy access.
• 2 year structural, 2 year hydraulic limited warranty
• Air operated locks
• Shipping weight: 1,215 LB.
Capacity - 7,000 LB.
Maximum Lifting Height - 41" (With positioning blocks)
Minimum Lifting Height - 4 ¼"
Overall Dimensions - 77 ½" (6' 5 ½") L x 72" (6') W
Platform Dimensions - 57 1/2" (4' 9 1/2") L x 19 ¼" (1' 7 ¼") W
Ramps - 10 ¼" x 19 ¼"
Between Runways - 33 ½" (2' 9 ½")
Air Requirement - 85-120 psi.
Motor/Electrical Requirement - 120 volt single (1) phase
A 30 amp breaker is required.
Oil Requirement - 3.5 Gallons AW32/AW46
Shipping Weight - 1,215 LB.
$3,895.00 + Tax
DELIVERY / INSTALLATION AVAILABLE
- CLENTEC ATLAS -
- SALES - SERVICE - PARTS -
- Tel - 226 2367379 -