2 POST HOIST 9000lb - ATLAS 9KOH - CLENTEC

- CLENTEC AUTOMOTIVE EQUIPMENT -

- SALES - INSTALLATION - SERVICE - PARTS -

- ST. CATHARINES - 905 207 2081 - TORONTO - 647 207 2081 - LONDON - 226 236 7379 / 226 456 7379

- $3070.00 + HST -

ATLAS - 9KOH ELITE - 2 Post 9000lb. HOIST

The Atlas 9KOH ELITE is the perfect choice for those customers who demand the most lifting capacity at the lowest possible price. It can be installed under a ceiling height as low as 11' 7". The overhead beam can be adjusted to two different height settings: 11' 6" or 11' 10".

The Atlas 9KOH ELITE includes:

• a complete set of solid peg type truck adapters mounting hardware • a set of sliding lift point adapters • a 220 volt single phase power unit that can be mounted on either side of the lift. (The power unit column must be on the correct side).

Highlights:

• 9,000 LB. capacity • Commercial grade Symmetric column design • Asymmetric arm design • Overhead Design • Clear Floor Design • Powder coat finish • Free 8 piece truck adapter set • Anchor bolts included

Benefits Of Our Atlas 9KOH ELITE 2-Post 9000lbs Capacity Carlift Dual Point Safety Release System:

The Atlas 9KOH ELITE has a dual point safety release system. Symmetric Columns and Asymmetric Arms:

The Atlas 9KOH ELITE has a symmetric column configuration that offers the widest possible Drive Thru, asymmetric arms to allow easy access to both sides of the vehicle, and two additional lifting pads that offer an infinite amount of lifting points for the rear lift arms. Chain-Over-Roller Cylinder Configuration:

The Atlas 9KOH ELITE has the chain-over-roller cylinder configuration. This above ground lift incorporates both the direct drive cylinder configuration and the chain-over-roller cylinder configuration. The base plate two post above ground lift implements the chain-over-roller configuration. This is the only hydraulic cylinder system that is possible in the base plate lift. The base plate two post above ground is designed for "low ceilings". The direct drive hydraulic cylinder configuration cannot be used in the base plate lift because the hydraulic cylinder would extend above the 9' 3" column when the lift arms were raised to the maximum height. The "overhead" two post above ground lift may incorporate either the direct drive hydraulic cylinder or the chain-over-roller hydraulic cylinder.

Electrical Requirements:

The electric motor for the power unit requires 220 Volt (single phase) 60 Hz. We recommend using at least a 10 gauge (grounded) wire from the electrical panel. The power unit has a short pigtail (no plug) that can be wired to either a quick disconnect box (mounted on the lift column) or to a male/female plug combination. A 30 amp breaker is recommended.

Installation:

Most of our above ground lift customers install their own car lifts. The average time to install the Atlas 9KOH ELITE car lift is four hours. We provide detailed installation instructions with all of our two post above ground lifts and our four post above ground lifts. Specifications; Capacity - 9,000 LB. Overall Height - 142" (11' 10") or 138" (11' 6") Overall Floor Width - 134 ¼" (11' 2 ¼") Outside Column To Outside Column - 124 5/8" (10' 4 5/8") Maximum Lift Height (Without Adapters) - 74" (6' 2") Maximum Lift Height (With Adapters) - 80 ¼" (6' 8 ¼") Minimum Pad Height - 4" Inside Column - 109 ¾" (9' 1 ¾") Column Size - 7 1/4" x 11 1/8" Drive Thru - 92 ½" (7' 8 ½") Base of Lift - 13 ½" x 18" Column Thickness of Steel - 5 gauge (.2", 5.08mm) Cable Diameter - .375" Motor/Electrical Requirement - 220 Volt, 220 volt single (1) phase A 30 amp breaker is recommended

- $3070.00 + HST

DELIVERY / INSTALLATION AVAILABLE

- CLENTEC -

- SALES - SERVICE - PARTS -

- ST. CATHARINES - 905 207 2081 - TORONTO - 647 207 2081 - LONDON - 226 236 7379 / 226 456 7379