Chevrolet For Sale in Ontario

Casc Gt 3 racer . 355 ci 4 speed, 9 in . New cell , seat . 4 sets tires/rims , Rains . Lots of spares . Let's talk , a great deal could be made . Season is here truck requires very little prep ( set ...

Could be road worthy, but needs a lot of work. Good parts truck. One owner. Full synthetic oil for the life of the truck. 5 speed manual. $6000 put into it, two years go. Body is tough. Any thoughts? ...

1996 s10 non running condition has rust asking 1500 obo.

I bought it a few weeks ago for my daughter but she doesn’t like it needs some body work and starter to runs motor was replaced sometime ago it’s not in bad shape for being this old may be open to ...

Looking to part out my S10 Blazer or buy everything, I would break even for $7000 but I’m open to offers. I have new parts, used parts, and two engines that both work fine before taking apart. I was ...

One of a kind truck. Custom built from a 1986 Chevy S10. Motor swap from the 4 cylinder 2.5l to a Chevy 350 V8 fuel inject full throttle body built by a professional racer, Electric fuel pump, dual ...

1987 S 10 zero rust, rolling chassis, no engine or transmission. Professional built rear frame with ladder bar. Brand New Ford nine inch 35 spline, rear coilovers, Brand New fuel cell. Too many ...

THIS IS A REAL UNIQUE VEHICLE WORTHY OF RESTORATION. I HAVE NEVER SEEN THIS TRUCK WITH A STEP BOX. 4.4 LITRE V6 RUNS GREAT! PRICE INCLUDES CAP AND TUNNEL COVER.

2000 Chevy s10 for sale it’s got around 319,xxx kms on it. 2.2 4 cylinder engine with a 5 speed transmission. Although it is a bit of a project truck it does run and drive good.. with that being said ...

Selling a 2003 Chevy S10 with the sportside/ stepside bed. The frame is broken but there are good parts on it and id like to sell it as a whole truck. The bed frender do have rust but its over still ...

Runs great better then most newer trucks 229888KM New front brakes and shocks Drivers side door needs new pins Need new coil spring on drivers side and a few holes in bumper.. Looking to trade for a ...

Looking for a first gen pro street s ten roller must be single cab short box don’t care bout body to much just want frame and rear diff must be shorten frame and fit wide tires. Looking for tubbed ...