Carvin Steve Vai Signature VL100 Legacy 2-Channel, All-Tube Ampl

Very good Condition, second owner, hardly used by myself. Beautiful Amp. CLEAN AND OVERDRIVE CHANNELS The equalization of the clean and overdrive channel is designed to offer clarity to your instrument. You will also take notice of the clean channels PRESENCE which adds acoustic voicing to your instrument. This switch boosts only the guitars very highest harmonics which are in the 10k Hz range instead of the normal 3K Hz of a bright switch. The PRESENCE control on the lead channel is designed to adjust the `edge` on your sound. It`s dynamic range allows for super-smooth sounds or turned the other way, it can add bite to your leads. DYNAMIC EL34 POWER TUBES Your amp is equipped with EL34 power tubes because of their smooth distortion, responsive sound and reliability. The compression characteristics of these `high-output` power tubes respond to the dynamic range of lead guitar playing. These tubes react even to the most subtle touch-if you play soft, the tubes remain clean and if you increase your attack they respond accordingly. The tube selection can also be changed to 5881/6L6 via a switch on the rear panel. TONE CONTROLS The T-Bridge passive BASS, MID and TREBLE tone controls offer a wide range of tone settings. Take full advantage by setting them where they sound best. Your sound may not be at center 5 on the dial. These controls will not affect or color your sound when set at extreme settings, nor do they interact with each other. The greater range of these controls comes from the high impedance 1 meg sealed pots (most guitar amps use 250k pots). The frequency of the bass control is set at 80 Hz while the mid control is set at 650 Hz. The treble control is set at a very high 11k Hz giving the Legacy it`s dynamic highs. REVERB The FS22 footswith for the long tailed REVERB system in the Legacy switches only the reverb `send` leaving the tail of the reverb to decay naturally, the way it`s done in the studio. A special pre filter eliminates the spring `boing` normally heard in other systems giving it a `lush` sound. The all tube reverb system offers vibrant clarity with full depth reminiscent of the sixties tube amps. Guitar Player magazine rated this system as one of the best they have heard. MODEL VL100 HEAD SPECS: -RMS Power: 50 or 100 watts -Output Impedance: 4, 8 & 16 ohms -Input Impedance: 470,000 ohms Tone Controls: -BASS: 80Hz (Both Channels) -MID: 600-700Hz -TREBLE: 11k Hz -Ch 1 Sensitivity: 16mV for clipping -Ch 2 Sensitivity: 30mV for full output -Channels: 2-switching -Voiced Line Out: 1.5 VAC @ 100 watts RMS -Preamp Tubes: 5-12AX7`s (dual stage) -Power Amp Tubes: 4-EL34`s (power pentode) -USA Model: 120VAC, 300VA -Cabinet Size: 24.25W x 10.5H x 9.5`D -Cabinet: 7-ply poplar wood -Net Weight: 40 lbs -Footswitch: FS22 footswitch included