OBD2 Adblue Emulator Plug Diesel Volvo Car Trucks
Adblue OBD2 Emulator for Trucks Plug and Drive Ready Device by OBD2
AdblueOBD2 is a plug and drive device to emulate working adblue systems and NOx sensors on desel trucks, which equipped with Euro 4/5 catalytic converter systems, even with damaged adblue SCR system.
Top 5 reasons to get adblueOBD2 Emulator for trucks: 1. AdblueOBD2 is very easy to install. Just plug the unit into OBD2 connector of truck or bus and remove fuses mentioned. 2. Adblueobd2 will override Adblue system instantly, and it will stop usage of adblue liquid and disable NOx sensors. 3. Without any power loss of engine or any warnings on dashboard as well as in diagnostic system. 4. AdblueOBD2 doesn't cause any negative effects on the truck factory settings 5. AdbllueOBD2 doesn't change any settings permanently. Unplug adblueOBD2 will turn back everything to truck's original settings.
Installation and Calibration for Trucks: 1. Pull the key out from ignition 2. Remove the Fuses F10 3. Plug adBlueOBD2 into OBD2 connector 4. Turn on ignition and check the level of adblue, it should shows 50% or 70% 5. If any fault light appears on dashboard, delete via serve scanner
Legal Notice: AdBlue/DEF (diesel exhaust fluid) is used to reduce NOx emissions in vehicles. We recommend to use adblue/DEF fuel all the time if possible. You can use this device only if you are unable to fuel up the adblue/DEF tank temporarily.