Ludwig Lightweight Flat-Base Cymbal Stands (1 pair)

Here are 2 matching Ludwig lightweight flat-based straight cymbal stands. These were being produced between the early 1990s through the early 2000s, as the Ludwig LT126CS model. The red label says "Made in Taiwan" in fine print above the usual Ludwig name (see pics). The stands are in very good shape, clean, with no rust or pitting, strong rubber feet with no splits or wear, and working perfectly. More specs: - They have 3 tiers - The max height that they can hold cymbals well is about 52" - The tilter is geared/toothed (i.e. fixed notches) - The length of each leg is 11.5" (FYI - the leg length on Tama Classic flat-base stands is only 9.5") I'd bought them as lightweight stands, to go with an older Ludwig kit I had. I later sold the kit but kept the stands for a practice set I had, which I also later sold. So I no longer need the stands. I like how flat-base stands allow you to place the cymbals closer than you can with a tripod stand, especially the ride cymbal. I was using 18" to 21" cymbals on these stands and they held well. There will always be a slight bit of wobbling with any lightweight flat-based stand. These stands are good for gigging but are best on relatively flat floors / surfaces. You can use them on outdoor gigs, as long as there's no strong winds blowing on the cymbals. I'm selling them TOGETHER AS A PAIR, and not splitting them up. Cash only, no trades or e-transfers, and pickup in Welland. Thanks for looking, please check out my other postings.