Radium Engineering Catch Can Kit for Mitsubishi Evo X

Please Contact
Posted
Mississauga, ON L5B2C9(View Map)
  • Make
    Mitsubishi

    Description

    Limitless Motorsports Authorized Canadian Radium Engineering Dealer Phone: (289) 805-2394

    ========================================================================== Radium Engineering offers two completely independent oil catch can kits for the Mitsubishi Evo X that are sold individually or together based on customer needs. ==========================================================================

    These catch can kits do NOT vent to atmosphere (VTA), thus are emissions and track legal. Closed loop systems route clean filtered air back in through the engine to be burned and to promote negative crankcase pressure for optimal performance. Furthermore, closed systems prevent unwanted oil vapors into the cabin.

    PCV Catch Can Kit The PCV Catch Can Kit is compatible with all 2008-up EVO X models. It installs immediately behind the RH headlight and plumbs in-line with the PCV hose. When the intake manifold pressure is close to or greater than atmospheric pressure, the PCV "check" valve closes and, thus, this hose experiences no flow. Conversely, the PCV hose will experience "metered" vacuum when the engine is idling, steady state cruising, and decelerating. This would normally draw unwanted crankcase vapor, unspent fuel, and oil sludge into the intake manifold immediately after a high load run.

    Note: Because the Radium catch cans are pressure sealed, they are great for boosted applications as well so connecting to the intake manifold is permitted and will withstand any boost level.

    PCV Kit Includes: -Radium billet oil catch can with integrated condenser and dipstick -Radium laser cut powder coated application specific mounting bracket -Anodized aluminum hose ends and adapter fittings -Rubber hose to mate to custom applications -Stainless steel mounting hardware

    Crankcase Catch Can Kit The Crankcase Catch Can Kit installs immediately behind the LH headlight and plumbs in-line with the crankcase vent hose. This is the hose that connects from the port on the valve cover to the turbo air intake pipe. On 2008-2009 EVO X models which use the "metal" valve cover, the hose is 3/8" (10mm) and requires P/N 20-0106-08. On 2010+ EVO X models which use the "plastic" valve cover, the hose is 1/2" (13mm) and requires P/N 20-0106-10. During low engine loads, this hose experiences atmospheric pressure, but when the engine is at high load (WOT), this hose will experience vacuum and would normally be drawing unwanted crankcase vapors, unspent fuel, and oil sludge into the air filter intake pipe, turbocharger compressor, etc. For instance. if you are finding oil accumulation stuck in the intercooler, this catch can is a necessity as oil will lower the thermal efficiency properties of the heat exchange process.

    Crankcase Kit Includes: - Radium billet oil catch can with integrated condenser and dipstick - Radium laser cut powder coated application specific mounting bracket - Anodized aluminum hose ends and adapter fittings - Rubber hose to mate to custom applications - Stainless steel mounting hardware

    Part Numbers 20-0105 - PCV Line Kit for all EVO X Models 20-0106-08 - Crankcase Kit for 08-09 Models 20-0106-10 - Crankcase Kit for 2010+ Models 20-0108-08 - Dual Catch Can Kit for 08-09 20-0108-10 - Dual Catch Can Kit for 2010+

    Contact Limitless Motorsports for All Your Radium Engineering Needs!

    842 visits
    Take steps to make your Kijiji transactions as secure as possible by following our suggested safety tips.Read our Safety Tips

    My Favourites ()

    Recently Added: