Kingston KVR1333D3D4R9S/8G PC3-10600 CL9 Registered (8X2=16GB)

This is a Kingston KVR1333D3D4R9S/8G PC3-10600 CL9 Registered (8X2=16GB) ECC MEMORY. Please make sure it's compatible with your system before you're buying it. No return accepted. I have 9 kits if you need more please let me know.

KVR1333D3D4R9S/8G

8GB 1024M x 72-Bit PC3-10600 CL9 Registered w/Parity 240-Pin DIMM

DESCRIPTION

This document describes ValueRAM’s 1024M x 72-bit 8GB (8192MB) DDR3-1333MHz CL9 SDRAM (Synchronous DRAM) registered w/parity, dual-rank memory module, based on thirty- six 512M x 4-bit DDR3-1333MHz FBGA components. The SPD is programmed to JEDEC standard latency 1333MHz timing of 9-9-9 at 1.5V. This 240-pin DIMM uses gold contact fingers and requires +1.5V. The electrical and mechanical specifications are as follows:

FEATURES

JEDEC standard 1.5V ± 0.075V Power Supply

VDDQ = 1.5V ± 0.075V

667MHz fCK for 1333Mb/sec/pin

8 independent internal bank

Programmable CAS Latency: 6,7,8,9,10

Programmable Additive Latency: 0, CL - 2, or CL - 1 clock

Programmable CAS Write Latency(CWL) = 7(DDR3-1333)

8-bit pre-fetch

Burst Length: 8 (Interleave without any limit, sequential with starting address “000” only), 4 with tCCD = 4 which does not allow seamless read or write [either on the fly using A12 or MRS]

Bi-directional Differential Data Strobe

Internal(self) calibration : Internal self calibration through ZQ pin (RZQ : 240 ohm ± 1%)

On Die Termination using ODT pin

On-DIMM thermal sensor (Grade B)

Average Refresh Period 7.8us at lower than TCASE 85°C, 3.9us at 85°C < TCASE ≤ 95°C

Asynchronous Reset

PCB : Height 1.180” (30.00mm), double sided component

SPECIFICATIONS

CL(IDD) Row Cycle Time (tRCmin)

Refresh to Active/Refresh Command Time (tRFCmin)

Row Active Time (tRASmin) Power UL Rating Operating Temperature Storage Temperature

9 cycles 49.5ns (min.) 160ns (min.)

36ns (min.) 4.365 W (operating) 94 V - 0 0° C to 85° C -55° C to +100° C