FUSION MARINE MS-DA51600 5-channel Marine Amplifier

PRICE INCLUDES TAX

FUSION MS-DA51600

Features

Marine Amplifier: The Fusion MS-DA51600 is a five-channel marine amplifier. It has a conformal-coated PCB circuit board protects it against the harsh marine environment. The amp's removable stainless steel top cover protects the control panel and the connection panel on the side. Its one-piece die-cast heat sink helps to dissipate heat from the internal components to provide greater reliability and longer sustained power output.

Class-D Amplifier Technology: The MS-DA51600 features a Class-D design to give you higher output and greater efficiency. It can power two pairs of full range speakers, plus a subwoofer. You can also bridge four channels to two and power three subwoofers. The power output specifications of the amp are as follows (at 14.4 volts input power):

80 watts RMS x 4 channels + 250 watts RMS x 1 channel at 4Ω 130 watts RMS x 4 channels + 330 watts RMS x 1 channel at 2Ω 250 watts RMS x 2 channels at 4Ω bridged + 250 watts RMS x 1 channel at 4Ω Protection Circuitry: The MS-DA51600 is equipped with 5-way protection circuitry that will keep the amp operating safely. The circuitry protects against overheating (thermal), reversed power polarity, DC offset, over-voltage, and under-voltage conditions.

Remote Level Controller: A Remote Level Controller is included with the amplifier that allows you to independently control the level of the subwoofer from the cockpit or driver's seat. A 19.5' cable is included with the controller.

Inputs and Outputs: The Fusion MS-DA51600 amplifier has marine-grade, nickel-plated RCA inputs and outputs, as well as stainless components that improve signal flow for optimum output. The amplifier's connections include:

Low-Level Inputs: The amp features three pairs of stereo RCA inputs to connect your marine audio source (Front, Rear, Sub). Speaker Outputs: The amp features 10 set-screw connections for a total of 5 speakers (left front, right front, left rear, right rear, and subwoofer). The terminals will accept up to 12-gauge wire. A Phillips-head screwdriver (not included) is required to tighten/loosen the set screws. Power Connections: The MS-DA51600 features nickel-plated set screw terminals for power, ground, and remote turn-on. The power (+12V) and ground (GND) terminals will accept up to 4-gauge wires, and require a Phillips-head screwdriver (not included) to tighten/loosen the set screws. The remote turn-on terminal will accept up to 8-gauge wire, and also requires a Phillips-head screwdriver. The recommended power and ground cable is 4 AWG with an 80-amp fuse on the power wire near the battery.

Controls: The Fusion MS-DA51600 provides independent controls for the front channels (1+2), rear channels (3+4), and the subwoofer. The controls are located on the top panel, under the removable stainless steel cover. (A 3mm Allen wrench is included to remove the cover screws.) A flat-head screwdriver (not included) is required to adjust the rotary controls. The controls include:

Front and Rear Channels: Separate controls are provided for each: Level: The rotary level control lets you match the head unit to the amplifier. Crossover Frequency: The crossover is continuously variable from 32 Hz to 320 Hz. Crossover Selector: This 3-way slide switch lets you select the configuration of the crossover. You can choose LP (low-pass), HP (high-pass), or Full Range. Subwoofer: Low Pass Frequency: The low pass filter is continuously variable from 32 Hz to 320 Hz. Level: The rotary level control lets you match the head unit to the amplifier. Audio Source: This switch lets you select the input source for the subwoofer. You can choose Sub if your source unit has dedicated subwoofer preamp outputs. If it does not, you can choose Front/Rear to use the Front and Rear inputs. Bass Boost: You can increase the bass output, centered at 45 Hz, from 0 to +12dB using the rotary control. Subsonic: The subsonic filter eliminates all of the sub-bass frequencies below the set frequency. This rotary control is variable from 10 Hz to 80 Hz.

Product Highlights:

5-channel marine amplifier 80 watts RMS x 4 at 4 ohms + 250 watts RMS at 4 ohms 130 watts RMS x 4 at 2 ohms + 330 watts RMS x 1 at 2 ohms 250 watts RMS x 2 bridged at 4 ohms + 250 watts RMS x 1 at 4 ohms polished stainless steel cover Class D design frequency response: 10-50,000 Hz in-cabin level control included RCA line-level inputs included 4-gauge power and ground leads recommended — wiring and hardware not included with amplifier 8-1/4" W x 2-1/16"H x 11-13/16"D

What's in the Box:

Owner's manual

5-Channel Marine amplifier Remote Level Controller module 19.75' Remote level control cable (RJ-14 plug on both ends) Two 40A ATO fuses (installed) Two spare 40A ATO fuses Cleaning cloth (6"x6") 3mm Allen wrench 4 Self-tapping screws (1" length) 2 Self-tapping screws (7/16" length) User/Installation manual Warranty information

LED Transom lights Night Underwater Wake Boat Wakeboat Wakeboard Wake Waterfire Night Boating Fishing Fish Ski Marina Sail Sailboat Speed Speedboat Cabin Cruiser Cabincrusier Dayboat Sportboat Led Lights Water Safety Dock Docking Marine audio Marine stereo Marine speakers Marine deck Boat stereo Boat speakers Boat audio Marine sub Marine subwoofer Polk Infinity Kenwood JBL Boss Polk Jensen JVC Pyle Planet Audio Milennia MTX Pioneer SONY Rockford Fosgate MBQuart Kicker Dual Clarion Alpine Aquatic AV JL Audio Boat Stereo Marine Subwoofer Fusion Wakeboard Offshore Speedboat Lake Boating Bowrider Cuddy Alpha Bravo1 Bravo3 Bravo I III Honda Suzuki Marine Volvo Penta Yamaha Mercury Outboards Nissan Marine OMC Johnson Outboards Mariner Outboards MerCruiser Evinrude Outboards Force Honda Marine