Fanuc MPG Electronic Handwheel, CNC Manual Pulse Generator

Kitchener, ON N2G1S6(View Map)



I Bought this but eneded up finding the problem with mine before it was used. It has the spring cable attached but no plug on the end and also the wiring diagram comes with it.

Voltage :5V, Pulse :100PPR Suitable For Fanuc Control Systems

Descriptions: •CNC system and position control of various mechanical devices,mainly for CNC machine tools and various mechanical zero correction and signal division. •100 times per revolution slightly cracking point,100 pulses per revolution output, holding the handle of the panel and all-metal high-grade design. •Metal code disc, high precision, good texture •Easy installation, shaped thin, ultra-light. •DC 5V power system •Voltage, single-ended, differential in three output options provide 100PPR pulse output options. •Driver output type, anti-interference ability, long-distance transmission. •Oil, water, dust-proof design (grade IP65) spiral stretch 20 million guaranteed. Features:

•Novelty, easy to move, interference, load capacity. •Full plastic shell, insulation, high strength, anti-oil seal design. •With × 1, × 10, × 100 third gear ratio, enabling 4 axis magnification switch •For CNC machine tools, printing machinery, numerical control equipment


Resolution 100PPR SupplyVoltage DC5V +/-5% SupplyCurrent ≤160mA Output Voltage ≥2.5V ≤0.5V Output Current +/-20mA Fall/Rise time ≤100ns Respence Frequency 0-5KHz

1,249 visits
Take steps to make your Kijiji transactions as secure as possible by following our suggested safety tips.Read our Safety Tips

My Favourites ()

Recently Added: