Yamaha CA-2010 Integrated Amplifier

Yamaha CA-2010 Integrated Amplifier Stereo Receiver ( CLASS A / B Amp )

This Yamaha CA-2010 was just professionally serviced and calibrated.

Professionally Serviced at URUK Electronic 226 39 Ave NE Unit 2, Calgary, AB T2E 2M5

It needed two miniature lightbulbs and many capacitors were replaced in the Power Supply Section.

All the controls and switches were cleaned and lubricated.

More info and better pictures coming.

Asking $1200.00 FIRM

Thank You for checking out my Ad. ( Other Vintage Equipment Available Soon )

Article Reviewer notes: This amp can work in Class A or Class B mode. If you want to make maximum out of her or your heating is broken, just flip Class A switch, you’ll get slightly better sound and also beautiful heating device, it’s very good for winter evenings. Class A uses much more power, and it can get quite hot, but you’ll get lower distortion and clearer tonal quality in exchange. Can you actually hear the difference? I doubt most people can. You also loose a little bit of output power, you’ll get 30 instead of 120 watts per channel, so it may need more efficient speakers than in Class B. Sure, she can get quite hot, but I’ve never felt she’s gonna overheat in Class A.

Article: https://www.karlsitretro.com/yamaha-ca-2000-ca-2010-review/

I saw two sell last month for Hundreds more. ( See Pictures )

============================================================

Specifications:

Power output: 120 watts per channel into 8Ω (stereo)

Frequency response: 5Hz to 50kHz

Total harmonic distortion: 0.005%

Damping factor: 45

Input sensitivity: 0.5mV (MC), 2mV (MM), 120mV (line)

Signal to noise ratio: 71dB (MC), 82dB (MM), 100dB (line)

Output: 120mV (line), 1V (Pre out)

Dimensions: 461 x 360 x 170mm

Weight: 21kg